Click here
to subscribe for 'Back-in-stock' notifications
Lister CS type decompression lever with fixing bolt for pivoting the arm into position under the valve lifter tappet.
Suitable for twin cylinder engines only.
Replacement casting for the cam shaft end support on twin cylinder engines, also acts as the mounting for the fuel pump and governor linkage assembly etc.
Supplied complete with a phosphor bronze bush fitted for the cam shaft.
Please select the correct type for the given side of the engine that the casting is required for. 574-10560 is for the end which carries the shut off lever which is also the gear end of the engine (see crankshaft to camshaft driving gear) and 574-10570 is for the flywheel end of the engine.
Lister CS twin cylinder crankshaft suitable for use in Lister twin cylinder CS 10-2, 12-2 and 16-2 engines using the white metal bush type of main bearings.
A traditional oil bath air filter assembly.
Supplied with a round pipe clamp on the bottom for fitting to the intake elbow of Lister CS twin cylinder engines i.e the 10-2, 12-2 and 16-2 models.
Twin cylinder crankcase door, comes complete with the breather studs and gasket.
A complete twin cylinder governor linkage assembly. Very well made and carefully painted, all parts move as they should and the surfaces are clean and smooth.
Comes complete with the governor spring and adjustable hook.
Click here
to subscribe for 'Back-in-stock' notifications
A pair of high pressure injector fuel lines suitable for twin cylinder CS engines.
A left and right hand pipe is supplied and whilst the number one cylinder is the same as used on single cylinder engines the number two cylinder requires a special pipe of the opposite hand.
A quality casting of the air inlet manifold for Lister CS twin cylinder engines.
The stud fixing holes have purposefully not been drilled, you will need to do this to suit your engines stud spacing thereby ensuring the best fit.
Suitable for Lister CS 10-2, 12-2 and 16-2 engines.
A complete set of oil pipe work for the twin cylinder engine. Includes the oil strainer and a rouge debris catching magnet. Picture coming soon.
Click here
to subscribe for 'Back-in-stock' notifications
A quality water manifold for either lower or upper connection of the water jackets on Lister CS twin cylinder engines.
The manifold purposefully does not have its stud holes drilled as this position varies from one engine to another. You will need to jig up and measure the position to drill the holes yourself to ensure the best fit for your engine.
Extremely good quality taper roller bearings suitable for Indian Lister CS type twin cylinder CS engines using the taper roller bearing system. This set includes the intermediate bush type bearing.