High quality aluminium or paper cylinder base shims available in a variety of thicknesses to allow for the fine adjustment of your Lister CS's bump clearance.
These aluminium shims should ideally be inter spaced between gaskets of the same type made from paper which are supplied in our full gasket sets or loose from this listing. The aluminium shims can be used without paper gaskets in between if every layer is bonded together with a jointing compound such as Heldite.
A high quality die cut gasket for the exhaust joint on all Lister CS, J, L and JP engines.
Lister P/N 003-00307 or 010-03057
A quality copper and non asbestos sandwich type head gasket suitable for use on either the 10-1 or the 20-2 Listeroid CS engines.
A quality copper and non asbestos sandwich type head gasket suitable for use on either 6 or 8 HP Listeroid CS engines fitted with the 5 stud type of cylinder head.
A genuine Lister die cut gasket for the top cover of the wick style fuel filter housing as used on Lister CS and JP engines.
Lister P/N 023-02278
A good quality die cut water flange gaskets for all Lister CS, JP and Listeroid CS type engines.
Equivalent to Lister P/N 010-02059
Good quality die cut gaskets for the air inlet manifold to cylinder head joint on all Lister CS and Listeroid engines.
Made from high quality asbestos free composite gasket material.
Quality aluminium bearing shims, available in three thicknesses to allow for the fine adjustment of your Lister CS crankshafts end float. Particularly useful for anyone wishing to convert their genuine Lister engine to the taper roller bearing system as this conversion necessitates the shimming up of the bearing carriers away from the crankcase by approximately 0.020" either side.
Two types are available, small for the old style engines with four mounting studs points on the tear drop shaped bearing carrier and large one for the Indian variants usually found on engines fitted with taper roller bearings using bearing carriers with five mounting stud points.
These shims should ideally be inter spaced between gaskets of the same type made from paper which are supplied in our gull gasket sets or they can be used without paper gaskets if every layer is bonded with a jointing compound such as Heldite.
Suitable for both original Lister CS engines and Indian Listeroid engines.
Equivalent to Lister Petter part number 008-02178
Equivalent to Lister Petter part number 088-02177
A quality copper and non asbestos sandwich type head gasket suitable for use on either the 12-1 or the 24-2 Listeroid CS engines.
A quality copper and non asbestos sandwich type head gasket suitable for use on either 6 or 8 HP Listeroid CS engines fitted with the 7 stud type of cylinder head.
A gasket for the camshaft end cover on single cylinder Listeroid CS engines.
A single gasket for the crank case access door on all single cylinder Listeroid CS engines.
A single gasket for the camshaft end cover / fuel pump support carting on single cylinder Listeroid CS engines.