A replaceable dry paper element type air filter assembly suitable for use on a huge variety of engines but especially Lister Petter engines.
A solid cast iron inlet elbow for use with Lister CS engines to mount an air filter assembly.
The size of the reduced section to mount the air filter on is approximately 44mm diameter.
A solid cast flange with a female 1,1/2" BSP thread for use on the exhaust outlet port of Lister CS, J and L type engines.
The centre to centre distance of the stud holes is approx 3.5" which equates to about 90mm.
This flange can also be used on the air inlet of a CS engine if required.
Equivalent to Lister P/N 003-00135
A traditional oil bath air filter assembly with a round pipe clamp on the bottom for fitting to the intake elbow which is available separately.
Good quality exhaust silencers suitable for Lister CS and L type engines and all other similar sized engine using a silencer with this thread size fitting. Supplied with a heat resistant black finish to help prevent corrosion and fitted with a male 1, 1/2" BSP threaded pipe for fitting directly into the exhaust elbow.
Quality Whitworth studs commonly found on the air & exhaust manifold flanges and the tappet clamp of the Lister CS engines but could be used for any application requiring this size of stud.