A good quality bridge rectifier incorporated into an aluminum housing for effective cooling. Ideal as a replacement for the type contained in the TFDW alternators, something I would always keep on the shelf for the day you hope wont happen!
A quality replacement Automatic Voltage Regulator suitable for our TFW and TFDW type alternators.
A good quality bridge rectifier mounted onto a large aluminum heat sink for effective cooling. Ideal as a replacement for the type contained in the ST alternators, something I would always keep on the shelf for the day you hope wont happen.
A good quality bridge rectifier mounted onto a large aluminum heat sink for effective cooling. Ideal as a replacement for the type contained in the STC type three phase alternators, something I would always keep on the shelf for the day you hope wont happen.
A pair of replacement brushes for ST alternators from 2KW to 10KW.
A pair of replacement sprung loaded brush holders for ST alternators ranging from 2KW to 10KW.
A replacement volt meter for the front of the control box on ST alternators. The meter has a range from 0-300 Volts therefore is only suitable for use with the single phase units.
A replacement indicator light for the control box of the ST alternators.
These AVR modules can be added to our range of ST alternators to enable a finer adjustment of the output voltage at a given speed/frequency. Customer feedback also indicates that the alternators respond quicker to heavy loads when fitted with one of these.
Two sizes of replacement slip ring assemblies for ST alternators
We always insist on importing only the best ST alternators available containing good quality bearings, however we are well aware that over time any moving part will be subject to wear.
If you find you need to replace your bearings in your ST alternator these are ideally suited for the job. These bearings are of a very high quality and sourced from a company within the UK.
Replacement key steels for the fixing of your pulley to the shaft of your ST Alternator. Two sizes available depending on the size of your alternator.
Solid cast steel lifting eye with a 12mm thread as used on our range of ST alternators but suited to many other applications. Bright plated to prevent corrsion.
A complete replacement control box for our range of ST alternators. Comes complete with a volt meter, indicator light, main fabricated box and rear entry grommets.
A replacement fully machined rear end bell housing suitable for use with our range of 3KW ST and STC alternators.
A replacement fully machined rear end bell housing suitable for use with our range of 5KW ST and STC alternators.
Categories
