An superbly made original style Petter starting handle suitable for the AV and AVA models and most engines with a 1,1/2" crankshaft. This starting handle usues the original style of rocker ratchet pin which is incorporated into the faithfully reproduced cast head and also has the original type of steel grip which rotates freely on the shaft. I bet you would be hard pushed to tell the difference between this and an original!
A good quality tractor style exhaust silencer as used on our petter engine powered pump and generator sets etc. This silencer could be used for any engine in need of a well made exhaust silencer that will accept the 2" female pipe which clamps down at the base. See the picture for the air cleaner below for an example of this silencer in use.
A good quality tractor style multi stage air filter as used on our Petter engine powered pump and generator sets etc. This filter could be used for any engine in need of a well made multi stage air filter that will accept the 1.5" female pipe which clamps down at the side of the main filter assembly. This filter has several stages of particulate removal including a top dust separation bowl with sight glass and several inner filters with an oil bath section located at the very bottom which can be removed for periodic cleaning. See the bottom half of the picture for an example of how the air cleaner is arranged, this is without a doubt our finest air cleaner to date.
A very good quality 10mm pitch ring gear which is the same as we fix to the flywheel rim on the Petter type engines to make a self start system.
A quality copper/non asbestos head gasket suitable for use on water cooled Petter AV1 and AV2 engines with an 80mm bore diameter.
A quality cork rocker cover gasket suitable for use with the AVA and PH series engines.
A top quality copper/non asbestos head gasket suitable for use on air cooled Petter AV engines with an 80mm bore diameter.
A top quality non genuine copper/non asbestos head gasket suitable for use on air cooled Petter PH engines with an 87.5mm bore diameter.
