A range of heavy duty cast iron adaptor flanges which allows a conventional free standing 2 bearing configuration alternator to be close coupled to an SAE bell housing of a driving engine.

A good quality bridge rectifier incorporated into an aluminum housing for effective cooling. Ideal as a replacement for the type contained in the TFDW alternators, something I would always keep on the shelf for the day you hope wont happen!

A quality replacement Automatic Voltage Regulator suitable for our TFW and TFDW type alternators.

A good quality bridge rectifier mounted onto a large aluminum heat sink for effective cooling. Ideal as a replacement for the type contained in the ST alternators, something I would always keep on the shelf for the day you hope wont happen.

A range of quality dual voltage 115/230V single phase alternators available in a range of sizes and prices, so you can find the configuration that works best for your application.

A quality Stamford type SX460 half-wave phase-controlled thyristor type Automatic Voltage Regulator (AVR). This solid state unit forms part of the exciation system for many Stamford brushless generators and regulates the generators voltage, the AVR circuitry includes under speed and sensing loss protection features.

A good quality bridge rectifier mounted onto a large aluminum heat sink for effective cooling. Ideal as a replacement for the type contained in the STC type three phase alternators, something I would always keep on the shelf for the day you hope wont happen.

Alternators, TFW alternators, generators, generator, three phase, brushless generator head, three phase brushless alternator, single phase generator

A quality Leroy R230 type Automatic Voltage Regulator.

A complete valve assembly suitable for use in the Lister domestic type water pump.

A pair of replacement brushes for ST alternators from 2KW to 10KW.

A range of quality dual voltage 115/230V single phase brushless alternators available in a range of sizes and prices, so you can find the configuration that works best for your application.

A pair of replacement sprung loaded brush holders for ST alternators ranging from 2KW to 10KW.

A quality replacement Leroy R438 type Automatic Voltage Regulator.

A quality Leroy R448 type Automatic Voltage Regulator.

A quality Leroy R449 type Automatic Voltage Regulator.

A replacement volt meter for the front of the control box on ST alternators. The meter has a range from 0-300 Volts therefore is only suitable for use with the single phase units.

A replacement indicator light for the control box of the ST alternators.

These AVR modules can be added to our range of ST alternators to enable a finer adjustment of the output voltage at a given speed/frequency. Customer feedback also indicates that the alternators respond quicker to heavy loads when fitted with one of these.

Two sizes of replacement slip ring assemblies for ST alternators

We always insist on importing only the best ST alternators available containing good quality bearings, however we are well aware that over time any moving part will be subject to wear.

If you find you need to replace your bearings in your ST alternator these are ideally suited for the job. These bearings are of a very high quality and sourced from a company within the UK.

A set of four AC brushes for use on 2.5KW, K series alternators and BKB S.A.E & C.T.R 609 Series alternators of both single and three phase output configurations either 50/60Hz.

We can also make almost any type and size of carbon electrical contact brush to your specification, please feel free to contact us for a quotation.

Solid cast steel lifting eye with a 12mm thread as used on our range of ST alternators but suited to many other applications. Bright plated to prevent corrsion.

A complete replacement control box for our range of ST alternators. Comes complete with a volt meter, indicator light, main fabricated box and rear entry grommets.

A replacement fully machined rear end bell housing suitable for use with our range of 5KW ST and STC alternators.

A set of two DC brushes for use on 2.5KW K series alternators, these are commonly found fitted to Lister CS Start-O-Matic sets.