An anti clockwise starter motor suitable for clockwise rotation Lister Petter applications.
Equivalent to:-
P/N 274898 for Petter PH & PC engines.
P/N 204-13273 for Lister SR2, ST1, ST2 and ST3 engines.
A clockwise starter motor suitable for anti clockwise rotation Lister Petter applications.
Equivalent to:-
P/N 274899 for Petter PH & PC engines.
P/N 204-13270 or 204-13275 for Lister SR4, ST1, ST2 and ST3 engines.
A general purpose fuel tank cap.
Bayonet fitting, dimensions as per the picture.
Ideal as a cost effective replacement where the sizes are suitable.
As used on Lister LD, LR, SL and SR engines to mount filter assembly on P/N 201-11613, 201-11614 or 201-11615.
A Lister fuel tank cap.
Lister P/N 366-08136 which supersedes P/N 027-03824 and 366-00091
Fitted to a wide range of Lister fuel tanks.
Click here
to subscribe for 'Back-in-stock' notifications
A high quality cast iron starting handle suitable for Lister LD, LR, SL, SR, ST and HR engines requiring a 1.5" diameter starting handle.
Equipped with a sprung loaded ratchet pin that engages with the crankshafts key way.
Will fit most Lister A & B Juniors, HR, HRW, LD, LR, SL, SR, ST, and SW.
Equivalent to Lister P/N 201-12510.
A genuine Lister inlet manifold for reverse rotation SR1 engines.
This manifold sweeps to the left above the exhaust which is not standard spec which was out to the right on P/N 201-51122 but this manifold P/N 570-11290 is for reverse rotation engines and is a slightly different shape.
 P-N 201-51122-ef61730d32ba57970bfc0afd62424fb7.png)
A genuine Lister inlet manifold for standard rotation SR1 engines.
Lister P/N 201-51122
A good quality 1/4" BSP swivel union plug / banjo bolt.
Equivalent to Petter P/N 831026
Suitable for use on the fuel filter assembly 284359 as commonly used on Petter AV, AVA, PH, PHW and Lister LD, SL, SR, ST engines etc.
Plated for corrosion resistance.
A traditional oil bath air filter assembly with a round pipe clamp on the bottom for fitting to an elbow.
Lister oil reservoir / priming cup.
Lister P/N 201-26480
Lister LD, LR, LPA, LPW, LPWS, SL, SR, ST, VA, Later 31/2 -1. 6-1, 8-1, 12-2 and 16-2 engines.
Petter AA, AB, ABW, AC, ACW, AD, P600, PH, PHW, PJ, PJW engines.
Replacement 1 gallon / 5 litre fuel tank suitable for Lister LD1, LR1, SL1, SR1 & ST1 engines.
Equivalent to Lister Petter part number 201-11283
Supplied complete with a leak off grommet and tank cap as well as the threaded union on the bottom of the tank.
The cap on the top is a conventional bayonet fitting with a rubber seal.
Approx. dimensions 8" tall x 10" Long x 4.5" wide
Click here
to subscribe for 'Back-in-stock' notifications
A genuine Lister fuel tank support block suitable for Lister LD2, LR2, SL2 & SL3, SR2 & SR3 and ST1 & ST2 engines.
Lister Petter part number 202-11490
A pair of new fuel tank straps for the smaller 5 Litre (1 Gallon) tanks fitted to Lister LD1, SL1, LR1, SR1 & ST1 engines.
These quality aftermarket straps are made to fit our new 1 Gallon tanks on P/N 201-11283, equivalent to 2 x P/N 570-10630.
Sold as a pair, 2 x strap assemblies included.
High quality cylinder kits for Lister SR engines.
These cylinder kits comprise of:- 1 x Cylinder equivalent to P/N 201-50632 and 1 x Piston assembly equivalent to P/N 570-10940
The piston assembly includes the rings, gudgeon pin and circlips.
A genuine Lister SL3, SR3 & ST3 engine crankshaft pinion.
Lister P/N 203-11140
New, older stock that has been carefully stored.
Lister SL and early SR inlet valve.
Lister Petter part number 201-19350
Approximate head diameter 32mm.
A Lister LD, LR, SL and SR valve, Lister Petter part number 201-19360.
This valve is fitted in engines as follows:-
Lister LR inlet and exhaust.
Lister LD inlet and exhaust on engines built after 1959 from engine numbers 11936LD19 & 61192LD29 (Valve 201-10363 was used on Lister LD engines built prior to 1959 up to engine numbers 11935LD19 & 6119LD29).
Lister SL exhaust.
Lister SR exhaust on engines built prior to 1970.
Approximate head diameter 29mm. Sold individually.
Non genuine Lister SR post 1970 inlet valve.
Equivalent to Lister part number 201-50871
Approximate head diameter 39mm.
Non genuine Lister SR post 1970 exhaust valve.
Equivalent to Lister part number 201-50891
Approximate head diameter 33mm.
Genuine Lister LD, LR, SL & SR governor control lever spring.
Lister part number 201-12330
Bryce, CAV, Lucas or equivalent fuel pump element for CAV and Bryce pumps fitted to Lister SR engines.
Equivalent to P/N 1-313
Please check suitability for your pump before purchasing.
Lucas 1/338 fuel pump delivery valve suitable for use in Lister LT, LV, LR, SR, ST, HA, HB and HR fuel pumps.
Lister fuel pump shims for Bryce FAOAB fuel pumps used on many Lister single and multi cylinder engines.
Fits the following applications and more:-
Lister LD, LR, SL, SR, ST, HR
Lister P/N 201-11520, 201-11530 & 201-11540
Available in a range of different thicknesses, please select accordingly from the options menu.
High quality injector nozzles suitable for the Lister SR series engines.
Equivalent to Lister P/N 201-50461
NOZZLE LONG STEM
Part No.1 - HL140S25C544
Part No.2 - 0 433 271 124
Part No.3 - DLLA140S328
Part No.4 - BDLL140S6439
Part No.5 - VH14029
Lister SR, ST and HR series fuel injector oil seal O ring.
Lister part number 351-51540
Genuine Lister SR, ST, TS & TR screw on type oil filter element.
Lister Part Number 201-55370
A genuine Lister SR fuel pump linkage adjuster screw.
Lister Petter P/N 201-19210
Item 14 in the expanded illustration.
New and supplied in original Lister packaging.
Genuine Lister SR small end bush.
Lister Petter part number 201-50540
New and supplied in original Lister packaging.
Lister SR big end bearings available in a range of sizes.
Lister Petter P/N 570-12170
Good quality non genuine Lister LR & SR main bearings.
Available on a variety of sizes and suitable for both the flywheel end and the gear end of LR and SR engines.
Equivalent to Lister Petter P/N 201-50060
Please select either standard or under size from the menu when ordering.
Lister LR & SR centre main bearings on standard size.
Lister Petter P/N 570-11171
Please select the size required when placing your order.
Lister LD, LR, LT, LV, SL and SR thrust washer set.
Lister Petter P/N 201-123810
Lister gear end crankshaft oil seal.
As used on the gear end of Lister LD, LR, SR and ST engines.
Lister Petter part number 201-13190
Lister reduction box oil seal.
As used on the 2:1, 3:1 and 1:1.61 reduction boxes commonly coupled to Lister LD, LR, SR and ST engines.
Lister Petter part number 201-22420
Lister style swivel union plugs / banjo bolts equivalent to Lister P/N 201-53400
Suitable for use on the Bryce FAOABO series cast iron bodied fuel pumps as fitted to the Lister LD, SL, SR and ST series engines.
Threaded 1/4" BSP 19TPI.